Load notes
Soft Start

Soft start matters when a generator must pick up motor loads without a hard current spike. On plants with pumps, compressors and packaged HVAC, the starting method often decides whether the set holds frequency or drops out on protection.
Not every load should hit a generator all at once. On South African industrial sites, motors, compressors, pumps, and HVAC can trip a set if startup is not staged properly. Soft Start covers load sequencing and reduced inrush planning for smoother generator pickup.
On a soft start review, the useful records are motor nameplate data, starter settings, and the order in which loads come on after mains failure. Across Gauteng, KwaZulu-Natal and the Western Cape, those details usually show whether the issue is inrush, bad sequencing, or a genset that is too small for the first step load. On the contact form, send the motor size and starter type.
Motor pickup details we check
- Motor kW and full-load amps listed
- Starter photo showing settings and labels
- Generator model or service page referenced
- Electrical contact name and site role
Soft start notes make more sense when read next to the generator and service pages tied to the same plant. One page shows the load behaviour, while the other pages pin down the set, panel and maintenance items involved.
Load step order on site
The Soft Start page deals with managing startup current where motors can hit the genset hard. It is especially relevant for pumps, compressors and other plant equipment that need a controlled start to avoid unnecessary trips or oversizing.
Begin with the largest motor that must start on generator supply and work backwards through the sequence. Highveld dust affects cooling, coastal corrosion affects terminals and enclosures, and repeated load shedding means many sites restart several times in one day. Johannesburg, Durban, Cape Town and outlying industrial areas all have different operating patterns, but startup current remains the item that catches plants out.
Get photos of the starter, generator controller and main distribution board before any settings are changed. A simple startup sheet near the panel helps operators remember which pump, fan or compressor should wait, and which load can come on first when utility power falls away.
Soft start records to keep
The handover should show starter settings, load order, and the reason each major motor sits where it does in the sequence. One clear operating sheet is far more useful on shift than a long chain of mixed comments with no amperage or timing values.
Link Soft Start with the runtime note and a load note before changing breaker sizes or widening the generator scope. Check ATS panel details against the existing changeover arrangement before any collection or delivery is arranged. Your plant load, the ATS panel already fitted and the hours you run through an outage decide the genset size.
- A startup sequence matched to site load
- Initial settings captured before adjustments begin
- Motor and panel records kept together
South African load conditions that matter
Sites near OR Tambo logistics routes, Sunnyrock workshops, and older Crown Mines industrial buildings often carry mixed-age plant with uneven starting behaviour. Many facilities are not building a new system from zero. They are adding generator support to existing pumps, compressors, chillers and conveyors during load shedding. If changeover gear, existing cabling or an older set is already in place, that must be stated from the start. Breakdown work should be logged separately from planned service visits and load reviews.
Salt air on coastal sites can affect contactors, terminations and enclosure condition, while inland dust loads radiators, filters and panel vents much faster. Frequent utility interruptions also change how often teams test auto start, transfer timing and motor restart delays. A site visit for soft start work is there to verify load, switching logic and access to the relevant equipment.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Starter settings and sequence notes
Soft start matters when a generator must pick up motor loads without a hard current spike. On plants with pumps, compressors and packaged HVAC, the starting method often decides whether the set holds frequency or drops out on protection.
Record the ATS panel settings on the same visit while timer delays, transfer logic and start sequence are still in front of the technician. That sheet should sit with the service note and runtime log so maintenance teams can trace whether a nuisance trip came from motor inrush, control settings or the generator itself.
